Guys quick question:
The stand pole (the non flexible one) that holds him in place:
For me when I screw it to the base it stops in a position where I can't leverage the natural bent. Should that bent be in such a way that it comes forward so that the top of the pole is "over the base" cause in my case it stops in such a way that it might as well be a straight rod instead of the bent. Basically the bent is on x axis / plane.
Difficult to explain in words. Sorry![]()
Sent from my iPhone using Tapatalk
Guys quick question:
The stand pole (the non flexible one) that holds him in place:
For me when I screw it to the base it stops in a position where I can't leverage the natural bent. Should that bent be in such a way that it comes forward so that the top of the pole is "over the base" cause in my case it stops in such a way that it might as well be a straight rod instead of the bent. Basically the bent is on x axis / plane.
Difficult to explain in words. Sorry![]()
Sent from my iPhone using Tapatalk
Question for you experienced/handy collectors: So I needed to re-glue the magnet to his upper trap armor, and though it's mostly unnoticeable, it doesn't sit completely flush once it's attached to the body, leaving a tiny gap between the trap and the upper right portion of the chest. I'd post a picture but even I know it's kind of ridiculous to be bothered by something practically no one would ever notice, but I notice.... lol.
Long story short, is there any way for me to un-glue the magnet and attempt to redo it? Used Krazy glue btw.
Thanks freaks!
I totally understand what you're saying. Basically when you screw the pole into the stand it is reversed where the pole (and subsequently the clip) holds the figure further back on the base instead of bringing the figure forward.
Yeah you could just not tighten it all the way as Craig Walker stated. It shouldn't have any real impact on the sturdiness when the figure is mounted. But I'd honestly recommend you just unscrew the pole completely and don't worry about over tightening or stripping the threads. As you can see, I've had plenty of experience with all kinds of IM stands (HT & 3rd Party ones) and sometimes you just need to be a bit forceful.
Question for you experienced/handy collectors: So I needed to re-glue the magnet to his upper trap armor, and though it's mostly unnoticeable, it doesn't sit completely flush once it's attached to the body, leaving a tiny gap between the trap and the upper right portion of the chest. I'd post a picture but even I know it's kind of ridiculous to be bothered by something practically no one would ever notice, but I notice.... lol.
Long story short, is there any way for me to un-glue the magnet and attempt to redo it? Used Krazy glue btw.
Thanks freaks!
Mine has the same issue as well.
Question for you experienced/handy collectors: So I needed to re-glue the magnet to his upper trap armor, and though it's mostly unnoticeable, it doesn't sit completely flush once it's attached to the body, leaving a tiny gap between the trap and the upper right portion of the chest. I'd post a picture but even I know it's kind of ridiculous to be bothered by something practically no one would ever notice, but I notice.... lol.
Long story short, is there any way for me to un-glue the magnet and attempt to redo it? Used Krazy glue btw.
Thanks freaks!
I had to un-glue one of the magnets on mine as I put it in backwards. I used a hairdryer to heat it up and then popped it out with a very thin screwdriver. Took a few attempts but it did pop and with no damage luckily. Only issue is the residue left on the magnet so it will have to be scraped off to allow it to lay flush when you glue it back in.
I wonder what sideshow would say/do about the issue.
Enter your email address to join: