men-at-arms
Freakzoid
- Joined
- Sep 3, 2009
- Messages
- 82
- Reaction score
- 0
Hi Folks!
This is an interest set for sign ups on getting 1/6 scale Aliens USCM Colonial Marine aluminum armor sets produced.
The idea is to get sets of 1/6 scale USCM armor in the various components as shown by the 1:1 scale counter part factory made in real aluminum.
The cost of the sets is unknown as this point and would vary pending the final number of collectors on this group run. But for a rough ball park figure, we'll shoot for between USD$100, if the number of pre-paid collectors is high, and USD$150 if that number was low. If the costs goes above the upper limit, then the run won't be made. So, perhaps we can say as of right now -- I'd expect the median of USD$125 per set should interest for this run proves to solid.
The final product will be sufficient to fully equip one(01) 1/6 scale Colonial Marine figure.
BTW -- we are shooting to include 1/6 scale aluminum shrouds in this run, should it be feasible to include the piece in the tooling process, so that we can have as accurate as possible all the equipment necessary to yield a state-of-the-art 1/6 scale Marine. This will be the goal anyways.
If this sounds like something which might excite you, please sign up below -- as I promise this will be your single shot to get in on something like this.
This is an interest set for sign ups on getting 1/6 scale Aliens USCM Colonial Marine aluminum armor sets produced.
The idea is to get sets of 1/6 scale USCM armor in the various components as shown by the 1:1 scale counter part factory made in real aluminum.
The cost of the sets is unknown as this point and would vary pending the final number of collectors on this group run. But for a rough ball park figure, we'll shoot for between USD$100, if the number of pre-paid collectors is high, and USD$150 if that number was low. If the costs goes above the upper limit, then the run won't be made. So, perhaps we can say as of right now -- I'd expect the median of USD$125 per set should interest for this run proves to solid.
The final product will be sufficient to fully equip one(01) 1/6 scale Colonial Marine figure.
BTW -- we are shooting to include 1/6 scale aluminum shrouds in this run, should it be feasible to include the piece in the tooling process, so that we can have as accurate as possible all the equipment necessary to yield a state-of-the-art 1/6 scale Marine. This will be the goal anyways.
If this sounds like something which might excite you, please sign up below -- as I promise this will be your single shot to get in on something like this.
