Thanks Fellas. I know that everybody are busy with their new Cobra Commander including me but I have managed to do most of the tail wing, rudder and the two main side fins. The secondary upper tail wing is yet to be fabricated. I planned to make all the control surfaces workable. Here are a couple of work in progress shots...
You can see the ailerons and the rudder are not done yet. I have made the desired thickness of the wings by creating a rib in between the top and bottom skin to recreate it properly in this scale. The is hard work and need a lot of repetition. It will give the wing strength and at the same time being light.
Another view.
Here are the two main side rudder. Again this is recreated to scale thickness.
The right and the left parts. The rudders are both detached at the moment. I will make this workable.
Here you can see the scale thickness and the "curve" of the wing.
A closer view...
Mock up of the tail section. This is how it roughly looks. I have to add detail to the tail then make the main root and attached the tail wings and fin. You can see the cross section of the wings itself.
I have also managed to complete the housing of the main landing skid.
Another view of the tail assembly from the front.
View from the top.
Here is the model as it stands. I never have thought that there are a lots of wings and control surfaces in this aircraft. Until the next update.