Statue Iron Man 1:4 Mk III Maquette

Collector Freaks Forum

Help Support Collector Freaks Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Just one...

tumblr_mas4t1p0wb1rnck98o1_400.gif
 
Been reading Igo in the 'other' place...

Yah, flying poses are THE WORST to make actually work without looking too weird… this was actually my design (pose and general concept) that I worked up in ZBrush, but getting him to suspend just right without looking lame is THE WORST… still not done with the design yet.
MkII it is then.
 
Been reading Igo in the 'other' place...


MkII it is then.

Gotta agree there that it will most likely be the Mark II which actually looks like it could be a statue in development. The concept design for the Mark VII looked off model a bit. I think the eyes were to big. So if the design isn't quite right that means he probably isn't even in the sculpting or 3D print stage yet.
 
They could go for the wallet and just make two versions, one clean and one BD. We always get repaints from the same statue, so why not some alternate BD option.

I'd be fine with that. I'd even be fine if it was minor battle damage.
 
Back
Top