^ I concur.
Hopefully someone has the Inflames fig as well as this, as it would be great to see a side by side comparison.
^ I concur.
Hopefully someone has the Inflames fig as well as this, as it would be great to see a side by side comparison.
Note. When I meant the small prongs at the back of the head, I should have said the small prongs at the top of the back armour. They look like little rectangular tabs. On one of
mine it snapped, luckily just on one one side, so should b able to glue back together without noticing too much. However if is totally broken on yours. You can unscrew the screw that attaches the back armours to the shoulder straps and get the entire thing replaced. Just a tip.
Sent from my iPhone using Tapatalk
and how do you get it replaced? from 3A?
i totally agree.. personally i don't like his chest armor it covered his head and skirt is too long, overall is good..3A killzone is perfect..can't wait for the next killzone figures from inflames and 3A (they'll make more 1/6 killzone)..InFlame's figure didn't look bad at all from the photos. It was a good attempt. But this figure from ThreeA look spectacular.
Just ordered mine from Big Bad Toys.
Looking great guys
As terrible as it sounds... I used my teeth. Only way I could do it. Even then the peg was too big for the hole on the gun hand and I had to use a knife to carve away at the plastic a little to make it big enough for the peg.
Enter your email address to join: