You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Collector Freaks Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
7. Now take your first jumper cable and connect from 5V USBC out over the LED2(flight mode) board into the BAT connector. This is...
-
Here is the actual circuit board under the switch. You can very easily solder a wire here and route it outside.
As further proof this...
-
I swapped the connectors around but the second wire(for headlights) is too short but can be extended if removing the glue from the wiring.
-
Loading…
-
Loading…